VOLTCRAFT 306 Mode D'emploi page 34

D) Tabular
Click the "Tabular" item. Subsequently, you can see the continuous tabular represen-
tation of the measured temperature values from T1 and T2 in real time. Below, plea-
se find a brief description of the various commands:
Sampling Rate
Here you can set the scanning speeds, i.e. how fast / frequently the screen is to be
refreshed. The maximum setting time is 59 minutes and 59 seconds. The shortest
setting is 2 sec., i.e. a new screen appears at intervals of 2 seconds (new measured
values, refer to bottom line).
? = Help
The item showing the question mark "?" is tantamount to the "Help" function in
which the various field commands are explained.
Main Menu
By clicking this item, you get into the main menu.
Output to Graph or icon next to the question mark
By clicking this item, the temperature values are displayed graphically in another
window.
"II"
By clicking the item next to the question mark, you can stop the current representa-
tion (= pause).
">", Run
By clicking the item ">" or "Run", you continue current representation.
"Eraser"-Icon
By clicking the icon next to the printer icon, you return the graph to the start.
Printer icon = Print
By clicking the printer icon, you issue the command to print the screen.
File or icons for folder and diskette
By clicking "file", another small window unfolds: "New" means "new folder" (create);
"Open" means: open an existing folder; "Save" means: save the contents of the table
in the current folder; "Save As" means: save contents of table in another folder
(=save under); "Print" means: Print table.
To close the "Tabular" window, you have to click "x" on the top right.
E) Item in the left center
Clicking this window icon causes the windows "Tabular", "Control Panel" and
"Graph" to appear once in a single window (overlapping).
F) Data Logger
Clicking this window icon causes a mix of "Tabular", "Graph", a "MAX MIN" repre-
sentation and "Data Sets" (data records) to appear. Normally, the window is empty.
To fill it with data, click the item "Load Data" once (appropriate icon offset to the
right, below). Subsequently, the saved data of the measuring device are transferred
31