Binzel Abicor iSTM Mode D'emploi page 43

iSTM
4 Disconnect the torch neck and remove it.
 6.3 Attaching the ABIROB
 6.4 Attaching the ABIROB
5 Dismount the iSTM from the robot.
 6.1 Fastening the iSTM to the robot on page EN-9
12 Disposal
For the disposal observe the local regulations, laws, provisions, standards and guidelines. For
the iSTM to be properly disposed of, it first must be dismounted.
 11 Dismounting on page EN-20
12.1 Materials
This product consists for the most part of plastics, steel and non-ferrous metals. Steel and non-
ferrous metals can be molten in steel and iron works and are thus almost infinitely recyclable.
The plastic materials used are marked in preparation for sorting and separation of the materials
for later recycling.
12.2 Consumables
Oil, grease and cleaning agents must not contaminate the ground or enter sewage systems.
These materials must be stored, transported and disposed of in suitable containers. Observe the
relevant local regulations and disposal instructions of the safety data sheets specified by the
manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the manufacturer of the
consumables.
12.3 Packaging
ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials
are always selected with regard to their possible recycling ability.
13 Spare parts
 appendix
BAL.0150 • 2020-08-03
®
A torch neck on page EN-13
®
W torch neck on page EN-14
12 Disposal
EN - 21