Binzel Abicor iSTM Mode D'emploi page 37

iSTM
6.5 Shortening the wire guide
1
6
1 Retaining sleeve
2 Central connector
Fig. 9
NOTICE
• New, but still unused wire guides have to be shortened to the actual length of the cable
assembly.
1 Strip the wire guide (6) 20 mm on the torch side.
2 Lay out the cable assembly (3) in stretched position.
3 Loosen the central connector (2) from the cable assembly (3) using the nut (4).
4 Unscrew the retaining sleeve (1).
5 Remove the old wire guide and replace it by a new one.
6 Place the retaining sleeve (1) turned by 180° onto the new wire guide (6) (side without
thread).
7 Cut off the protruding wire guide (6) flush with the retaining sleeve (1).
BAL.0150 • 2020-08-03
2
3
4
Shortening the wire guide
Cable assembly
Nut
6 Putting into operation
3
4
5
5 Collet
6 Wire guide
EN - 15