Technical Data - Roco LINE Mode D'emploi

The Model
GB

Technical Data

Prototype design . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22-meter standard turntable
Model Scale . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1:87 (model size HO)
Bridge length of model . . . . . . . . . . . . . . . . . . . . . . . . . . . 253 mm (9.96")
Usable bridge length . . . . . . . . . . . . . . . . . . . . . . . . . . . . all rolling stock with total wheelbase not exceeding 250 mm (9.84").
Diameter concrete wall simulation in segments . . . . . . . . . . . . . . 307 mm (12.1")
Number of possible track connections . . . . . . . . . . . . . . . . . . . 40
Diameter overall including all access tracks . . . . . . . . . . . . . . . . 393 mm (15.47")
Required diameter of circular cutout in layout table . . . . . . . . . . . . 280 mm (11.02")
Required minimum depth of empty space requiredfor
installation of turntable beneath thecutout, measured from
upper edge of cutout or lower edge of access tracks. . . . . . . . . . . . 50 mm (1.96")
Smallest departure angle between two adjacent tracks . . . . . . . . . . 9°
Possible departure angle between adjacent tracks . . . . . . . . . . . . . in steps of 1° starting at 9°
Smallest angle between two track centres for reliable
recognition of track connection by the turntable control . . . . . . . . . . 3° (see fig. 7)
Angle of available concrete segment(filler pieces) . . . . . . . . . . . . . 1°, 3°, 6° and 9°
Control modes (track selection) . . . . . . . . . . . . . . . . . . . . . . a) single-step progress with manual control (operating
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . b) direct selection of track wanted through pre-selector control Art.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . c) control via PC (however required interface currently not planned
Powertransmission . . . . . . . . . . . . . . . . . . . . . . . . . . . . . via combined, two-stage worm gear and multi-stage spur gears; the
20
42615 Anleitung deutsch.indd 20
switch included with set);
no.42618
for production!).
second worm gear is directly attached to the bridge pivot and con-
nected to it by a slip clutch so that the bridge can be turned by hand
without damaging either of the two worm gears!
31.01.2011 09:18:56