Continuity Test - Klein Tools VDV500-063 Manuel D'instructions

ENGLISH
To ensure safe operations and service of the instruments, follow these
instructions. Failure to observe these warnings can result in re,
electric shock, severe injury or death.
The Toner-Pro and Probe-Pro (sold seperately) are designed for use on extra-low
•
voltage cabling systems (less than 60 volts) for testing when NOT energized.
The maximum voltage across ABN Test Clips of the Toner-Pro is 60 volts in
•
Test mode, and 20 volts in Continuity mode. Connecting the Probe-Pro to live
mains AC power may damage it and pose a safety hazard for the user.
DO NOT use instruments if they are wet, as it could pose a shock hazard.
•
DO NOT use instruments if they are damaged in any way.
•
Turn off instruments and disconnect all ABN Test Clips before attempting to
•
replace batteries.
The battery door must be in place and secure before you operate the instrument.
•
DO NOT open the case, other than the battery compartment.
•
READ ALL INSTRUCTIONS BEFORE OPERATING AND RETAIN
INSTRUCTIONS FOR FUTURE REFERENCE

CONTINUITY TEST

The Toner-Pro transmits frequencies on non-energized wires only. When the
Toner-Pro is turned on, a continuity test will be performed to determine if the 2
wires to be traced are in close proximity to each other, without a conductive path
between them. The "CONT" Indicator
Attach the red and black ABN Test Clips
resistance of the circuit is less than 10k , the "CONT" Indicator
red and no toning can occur. If the "CONT" Indicator is illuminated green, a tone
can be generated and you may proceed.
SELECTING TONE FREQUENCY
The Toner-Pro defaults to the 800Hz frequency setting when powered on. Use
the Tone Mode Up
frequency. The Tone Frequency Indicators
transmitted. If an alternating tone is selected, the two respective Tone Frequency
Indicators will blink. Tones will cycle through the available frequencies in a
T6
continuous loop when a selector button is pressed repeatedly.
TRACING PAIRED WIRES (FIG. 1)
1. Connect the Toner-Pro's red ABN Test Clip
pair to be traced. Connect the black ABN Test Clip
be traced.
2. Turn Toner-Pro on by pressing the Power On/Off button
3. Check the "CONT" Indicator
4. Select the preferred tone setting using the Tone Mode Up
Mode Down
T7
5. Turn on the Probe-Pro (sold seperately).
6. At the far end of the cable, spread the wires apart at least 2" (51 mm), if possible.
7. Use the Probe-Pro (sold seperately) to scan the cable's wire pairs. Move the
Probe-Pro's tip slowly across the wires. The Probe-Pro's volume will increase
as it approaches the toned pair. When the Probe-Pro's volume is high over
the first wire, low in the middle (between) the two wires, and high over the
second wire, you have located the pair of wires you are tracing. Use the
Volume Increase and Volume Decrease buttons to adjust the volume.
4
WARNINGS
OPERATING INSTRUCTIONS
and Tone Mode Down
T8
. If illuminated green, you may proceed.
T4
selector buttons.
wIll illuminate green to indicate pass.
T4
to the wires to be tested. If the
T14
selector buttons to change the
T7
will display the frequency being
T6
to one of the wires of the
T14
T14
will illuminate
T4
to the other wire to
.
T9
and/or Tone
T8