HAND START
ELECTRICAL START
NOTE
NOTE
Start the engine as follows:
1.
Push the choke into the Start position "see inscription on
the air filter" (only for a cold engine).
2.
Set engine switch to the "ON" position.
3.
Slowly pull the cord grip to the pressure point, and then
give it a rapid even pull.
The engine starts.
Support yourself with a hand on the grip on the device to
make pulling easier.
4.
Set the choke in its basic position.
The engine has started.
1. Push the choke into the Start position "see inscription on
the air filter" (only for a cold engine).
2. Turn the key-operated switch all the way to the right into
the START position until the engine starts and then
release.
The engine starts.
3. Set the choke in its basic position.
The engine has started.
Only activate the starter briefly (max. 5 - 10 seconds). Never
start or run the engine with the battery disconnected.
The electrical consumers can be connected or switched in
after a warming-up phase of about one minute.
Commissioning
Starting the generator
27