Replacing/Charging The Batteries; Storage And Maintenance - Beurer janosch JBY 92 Mode D'emploi

• The following additional factors can interfere with the baby
monitor's transmission or shorten its range: covering the units,
furniture, walls, houses, trees, environmental factors (such as
fog, rain)
10

replacing/charging the batteries

If the batteries are too flat, then the units will switch off automatical-
ly. The batteries must then be replaced or recharged (see Initial use).
• When changing the batteries, use batteries of the same
type, make and capacity.
• Always replace all batteries at the same time.
• Use batteries free from heavy metals.
11

storage and maintenance

The service life of the devices depends on careful use:
Warning:
• Remove the batteries from the baby unit if the unit is not
in use for an extended period.
• You will get the maximum capacity from your battery if
you run down the battery at least once every 6 months.
To do this, disconnect the device from the mains and run
the battery down through normal use. Then fully charge
the battery up again.
27