Resetting The Device To Factory Settings; Technical Data; Useful Information About The Baby Monitor - Beurer Janosch JBY 103 Mode D'emploi

Camera control
You can set the following parameters for your camera here:
Brightness, Contrast, Saturation and Frame Rate.
• In order to be able to set the parameters, you must first select the channel
number of your camera (e.g. CH1, CH2, etc.) with the arrow buttons.
Confirm your selection with the OK/Menu button. Now you can adjust the
individual parameters of the camera with the arrow buttons.
• To exit the menu again, press the On/Off button.
Version
The software version that is currently being used on the device can be read
off here.
Default
Resets all settings to the factory settings.
If no button is pressed for five seconds, or the On/Off button is pressed, the
settings menu disappears.

resetting the device to factory settings

To reset the device to factory settings, use a sharp object to press the reset
button on the monitor and on the camera.
8

technical data

• 16 channels
• Frequency 2.4 - 2.483 GHz
• Digital receiver
• 2.4" TFT display
• Infrared technology
• ECO mode
• Dimensions: camera Ø 82 mm x 75 mm / base: Ø 90 mm /
monitor: 130 x 76 x 31 mm / stand: 105 x 64 x 45 mm
• Weight: camera 93 g; monitor 117 g; battery 80 g
• 200 m range with a clear view
Operation
Battery life
(dependent on battery state,
ambient temperature, method and
frequency of charging, etc.)
9

useful information about the baby monitor

• If you operate the monitor with the battery, this minimises electrosmog
from electrical and magnetic alternating fields.
• You can increase the range of the baby monitor by positioning the camera
as high up as possible near a door or window and ensuring that the
battery is not too weak.
• Other radio waves may interfere with the transmission of the baby monitor.
Therefore, do not position the baby monitor near devices such as micro-
waves, WLAN, etc.
• The following other factors can interfere with the baby monitor's trans-
mission or shorten its range: furniture, walls, houses, trees, environmental
factors (such as fog, rain).
18
Camera and monitor mains part plug:
input: 100-240 V ~50/60 Hz, 200 mA;
output: 5 V 1 A
Monitor:
Lithium ion battery 3.7 V; 900 mAh
Monitor: approx. 9 hours in ECO mode
approx. 5 hours in LCD mode