Battery Operation - Beurer Janosch JBY 103 Mode D'emploi

Operation with mains part plug:
Plug the monitor into a socket using the mains part plug.

Battery operation:

The battery must be charged for at least eight hours before the monitor can be
first used independently of the mains. You can operate the device during this
time, however this will prolong the charging period.
you can either charge the battery with the mains part plug inserted into
the socket or with a usB cable plugged into a computer. (usB cable not
included in delivery)
When the battery level is low, you will hear an acoustic signal.
If the monitor is operated using a mains part plug and there is a power cut, it
switches to battery operation. For this reason, the standby time is dependent
on the battery charge status.
• Position the camera so that it is in an elevated position and is not in proxi-
mity to any other devices that may cause interference.
• Set the camera angle by turning the camera.
7 Operation
• Press and hold the On/Off button on the camera for ~5 seconds.
• Press and hold the On/Off button on the monitor for ~3 seconds. After a
few seconds, a start logo appears on the display, followed by the camera
transmission image. If the transmission image does not appear on the
display, check that the mains part plug on the camera is connected to a
socket.
• If you have connected several cameras and would like to switch between
the individual cameras, press the up or down arrow buttons on the
monitor.
• To set your desired volume on the monitor, press the right or left arrow
buttons during operation.
settings
You can select the following settings on your monitor: zoom function, pan
camera image in the zoom window, sound alarm, motion alarm, infrared
night vision and system settings.
• To access the settings menu, switch the monitor on and press the OK/
Menu button. The settings menu appears at the bottom of the monitor
screen.
• Select your desired menu option using the left and right arrow buttons:
zoom function
With the zoom function, you can enlarge one of five sections of the transmissi-
on image on the display.
• In order to activate the zoom function, select this menu option
press the OK/Menu button.
• Now use the arrow buttons to select the extract that you would like to
enlarge and confirm with the OK/Menu button.
• If you would like to switch back to the full transmission image, press the
OK/Menu button, select
16
and confirm with the OK/Menu button.
and