GE GLDT690JWW Instructions D'installation page 12

STEP 16 – DISHWASHER WET TEST
Turn on power supply or plug power cord into outlet.
Turn on dishwasher by pressing any button with the door open.
Select Normal cycle.
Press Start/Reset and close the door within 4 seconds. There will be a 5 second pause, followed by a 60 second pump-
out.
Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water
and power are turned on.
Check for leaks under the dishwasher. If a leak is found, turn power supply off, then tighten connections. Restore power
after leak is corrected.
Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent
cabinetry. Reposition the dishwasher if necessary. See step 11.
The dishwasher will drain about 12 minutes after the first fill. Check drain lines. If leaks are found, turn power off and correct
plumbing as necessary. Restore power after corrections are made. See Step 13.
Open dishwasher door and make sure most of the water has drained. If not, check that disposer plug has been removed
and/or air gap is not plugged. See Step 13. Also check drain line for kinking.
Run the dishwasher through another fill and drain cycle. Check for leaks and correct if required.
STEP 17 – REPLACE TOEKICK
Install 2 toekick screws to fasten toekick. Allow the toekick to touch the floor. NOTE: You may have to open the dishwasher
door to access the toekick screws.
STEP 18 – LITERATURE
Be sure to leave complete literature package and Installation Instructions with consumer.
The manufacturer, following a policy of constant development and product updating may make modifications without giving prior notice.
Installation Instructions
Adjust up
or down
12
2-Screws