Télécharger Imprimer la page
GE GDF510PSDSS Instructions D'installation
Masquer les pouces Voir aussi pour GDF510PSDSS:

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

GE Appliances
Installation Instructions
Built-In Dishwasher
If you have questions, call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com.
In Canada, please call 1.800.561.3344 or visit www.geappliances.ca
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT –
ordinances.
• Note to Installer – Be sure to leave these instructions for the
consumer's and local inspector's use.
• Note to Consumer – Keep these instructions with your
Owner's Manual for future reference.
• Skill Level – Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills. Proper
installation is the responsibility of the installer. Product
failure due to improper installation is not covered under
the GE Appliance Warranty. See warranty information.
• Completion Time – 1 to 3 Hours. New installations require
more time than replacement installations.
All manuals and user guides at all-guides.com
Observe all governing codes and
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
IMPORTANT –
The dishwasher MUST be installed
to allow for future removal from the enclosure if service is
required.
Care should be exercised when the appliance is installed or
removed, to reduce the likelihood of damage to the power
supply cord.
If you received a damaged dishwasher, you should immediately
contact your dealer or builder.
Optional Accessories – See the Owner's Manual for available
custom panel kits.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS shown
throughout these instructions. While performing
installations described in this booklet, gloves, safety glasses
or goggles should be worn.
31-31506-1 06-12 GE

Publicité

loading

Sommaire des Matières pour GE GDF510PSDSS

  • Page 1 All manuals and user guides at all-guides.com GE Appliances Installation Instructions Built-In Dishwasher If you have questions, call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com. In Canada, please call 1.800.561.3344 or visit www.geappliances.ca BEFORE YOU BEGIN IMPORTANT – The dishwasher MUST be installed...
  • Page 2 All manuals and user guides at all-guides.com Installation Preparation PARTS SUPPLIED IN INSTALLATION PACKAGE: Junction box cover and #10 hex-head screw ■ Hose clamp ■ Hose Clamp #10 hex screw Junction Hex-Head Drain Hose Drain hose (approximately 78" long) ■ Box Cover Junction Drain hose hanger...
  • Page 3 All manuals and user guides at all-guides.com Installation Preparation PREPARE DISHWASHER ENCLOSURE WARNING: To reduce the risk of electric shock, fire, or injury to persons, the installer must ensure that the dishwasher is completely enclosed at the time of installation. ADVERTENCIA: This Wall Area must be Free...
  • Page 4 All manuals and user guides at all-guides.com Installation Preparation PREPARE ELECTRICAL WIRING Alternate Receptacle WARNING: Location FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker 18" before beginning installation. Do not use an extension cord or 1-1/2" Dia. Hole (Max.) Receptacle adapter plug with this appliance.
  • Page 5 All manuals and user guides at all-guides.com Installation Preparation PREPARE HOT WATER LINE CAUTION: • The line may enter from either side, rear or floor within the Do not remove wood base until you are ready to install the shaded area shown in Figure F. dishwasher.
  • Page 6 All manuals and user guides at all-guides.com Dishwasher Installation STEP 1: PREPARATION STEP 3: REMOVE WOOD BASE, INSTALL LEVELING LEGS Locate the items in the installation package: • Screws IMPORTANT – • Junction box cover Do not kick off wood base! •...
  • Page 7 All manuals and user guides at all-guides.com Dishwasher Installation STEP 5: INSTALL 90° ELBOW STEP 7: POSITION WATER LINE AND HOUSE WIRING • Wrap a 90° elbow with Front of Dishwasher thread seal tape. • Position water supply line and house wiring on the floor of the •...
  • Page 8 Bend and break Screw here if necessary Figure P If you would like to order the Trim Kit from GE Service, please call 800.GE.Cares and request part number WD08X10094 for BB models or WD08X10096 for WW or CC models. Bracket...
  • Page 9 All manuals and user guides at all-guides.com Dishwasher Installation STEP 12: PUSH DISHWASHER INTO STEP 13: LEVEL DISHWASHER FINAL POSITION IMPORTANT – Dishwasher must be level for proper • Check the tub insulation blanket, if equipped, to be sure it is dish rack operation, wash performance and door operation.
  • Page 10 All manuals and user guides at all-guides.com Dishwasher Installation STEP 15: CONNECT WATER SUPPLY STEP 14: POSITION DISHWASHER, SECURE TO COUNTERTOP OR CABINET Connect water supply line to 90° elbow. • Slide compression nut, then ferrule over end of water line. In this step you will need the 2 Phillips special head screws •...
  • Page 11 All manuals and user guides at all-guides.com Dishwasher Installation STEP 16: CONNECT DRAIN LINE (Cont.) STEP 17: CONNECT POWER SUPPLY If a power cord with plug is already installed proceed to • Connect drain line to air gap, waste tee or disposer Step 18.
  • Page 12 All manuals and user guides at all-guides.com Dishwasher Installation STEP 18: PRETEST CHECKLIST STEP 19: DISHWASHER WET TEST Review this list after installing your dishwasher to avoid Turn on power supply or plug power cord into outlet, ■ charges for a service call that is not covered by your if equipped.
  • Page 13 All manuals and user guides at all-guides.com Dishwasher Installation STEP 20: REPLACE TOEKICK STEP 21: LITERATURE • Place toekick against the legs of the dishwasher. • Be sure to leave complete literature package, these Installation Instructions and product samples and/or coupons with the consumer.
  • Page 14 All manuals and user guides at all-guides.com Notes...
  • Page 15 All manuals and user guides at all-guides.com Notes...
  • Page 16 All manuals and user guides at all-guides.com SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE GE Appliances General Electric Company imagination at work Louisville, Kentucky 40225 GEAppliances.com © 2012 General Electric Company...
  • Page 17 à une installation inadéquate n’est pas couverte par la (ATTENTION et AVERTISSEMENT) données dans les présentes garantie de GE. Reportez-vous à la garantie du produit. directives. Pour effectuer l’installation décrite dans les • Durée de l’installation – Entre 1 et 3 heures. L’installation présentes directives, il faut porter des gants et des lunettes...
  • Page 18 All manuals and user guides at all-guides.com Préparation pour l’installation PIÈCES FOURNIES DANS L’EMBALLAGE: Couvercle de la boîte de jonction et vis à tête ■ hexagonale n° 10 Vis à tête Collier Couvercle #10 hex screw Boyau de vidange Collier ■...
  • Page 19 All manuals and user guides at all-guides.com Préparation pour l’installation PRÉPARATION DE L’OUVERTURE DANS AVERTISSEMENT: LES ARMOIRES Pour réduire les risques de choc électrique, d’incendie ou de blessures, l’installateur doit s’assurer que le lave-vaisselle est complètement encastré au moment de l’installation. •...
  • Page 20 All manuals and user guides at all-guides.com Préparation pour l’installation PRÉPARATION DU CÂBLAGE ÉLECTRIQUE Autre emplacement possible pour la AVERTISSEMENT: prise de courant POUR VOTRe SÉCURITÉ PeRSONNeLLe: enlevez le fusible ou 46 cm (18 po) déclenchez le disjoncteur au panneau de distribution principal Trou de 3,8 cm avant de commencer l’installation.
  • Page 21 All manuals and user guides at all-guides.com Préparation pour l’installation PRÉPARATION DE L’ALIMENTATION EN ATTENTION: EAU ChAUDE N’enlevez pas la base de bois avant d’être prêt à installer le lave- • La conduite peut entrer du côté gauche, du côté droit, vaisselle.
  • Page 22 All manuals and user guides at all-guides.com Installation du lave-vaisselle ÉTAPE 1: PRÉPARATION ÉTAPE 3: ENLÈVEMENT DE LA BASE DE BOIS, INSTALLATION DES PIEDS Prenez les pièces fournies dans l’emballage et mettez-les de côté: • ensemble de vis DE NIVELLEMENT •...
  • Page 23 All manuals and user guides at all-guides.com Installation du lave-vaisselle ÉTAPE 5: INSTALLATION ÉTAPE 7: POSITIONNEMENT DE LA DU COUDE DE 90° CONDUITE D’EAU ET DE L’ALIMENTATION ÉLECTRIQUE Devant du lave-vaisselle Front of Dishwasher • Appliquez du ruban pour joints filetés sur les filets du coude •...
  • Page 24 échéant no° 8 Si vous souhaitez commander l'ensemble de moulures du Service Ge, veuillez composer le 1.800.561.3344 et demander le numéro de pièce WD08X10094 pour les modèles BB, ou le Support no WD08X10096 pour les modèles WW ou CC.
  • Page 25 All manuals and user guides at all-guides.com Installation du lave-vaisselle ÉTAPE 12: INSTLLATION DU LAVE-VAISSELLE ÉTAPE 13: MISE DE NIVEAU DU DANS SON EMPLACEMENT LAVE-VAISSELLE DÉFINITIF IMPORTANT – Le lave-vaisselle doit être de niveau • Vérifiez l’isolant de la cuve, s’il y a lieu, pour vous assurer pour assurer le bon fonctionnement des paniers et de la porte qu’il enveloppe complètement la cuve.
  • Page 26 All manuals and user guides at all-guides.com Installation du lave-vaisselle ÉTAPE 14: FIXATION DU LAVE-VAISSELLE AU- ÉTAPE 15: RACCORDEMENT DE L’ALIMENTATION EN EAU DESSOUS DU COMPTOIR OU AUX CÔTÉS DES ARMOIRES Raccordez la conduite d’alimentation en eau au coude de 90°. •...
  • Page 27 All manuals and user guides at all-guides.com Installation du lave-vaisselle ÉTAPE 16: RACCORDEMENT DU BOYAU • Branchez le boyau de vidange à la coupure anti- refoulement, au raccord en T ou au broyeur à déchets DE VIDANGE à l’aide de la méthode choisie précédemment. Fixez L’extrémité...
  • Page 28 All manuals and user guides at all-guides.com Installation du lave-vaisselle ÉTAPE 17: BRANChEMENT DE ÉTAPE 18: LISTE DE CONTRÔLE L’ALIMENTATION ÉLECTRIQUE PRÉLIMINAIRE Si un cordon d’alimentation pourvu d’une fiche est déjà Passez en revue cette liste après l’installation de votre installé...
  • Page 29 All manuals and user guides at all-guides.com Installation du lave-vaisselle ÉTAPE 19: ESSAI DU LAVE-VAISSELLE ÉTAPE 20: RÉINSTALLATION DU PANNEAU AVEC DE L’EAU INFÉRIEUR Rétablissez l’alimentation électrique ou si l’appareil est doté • Appuyez le panneau inférieur contre les pieds de nivellement ■...
  • Page 30 All manuals and user guides at all-guides.com Notes...
  • Page 31 All manuals and user guides at all-guides.com Notes...
  • Page 32 All manuals and user guides at all-guides.com LeS SPÉCIFICATIONS PeUVeNT ÊTRe MODIFIÉeS SANS PRÉAVIS Ge Appliances General electric Company imagination at work Louisville, Kentucky 40225 www.electromenagersge.ca © 2012 General electric Company...