Lighting Instructions; Burner Assembly - Napoleon PATIOFLAME Mode D'emploi

14

Lighting Instructions

EN
WARNING!
property damage, personal injury or loss of life.
WARNING!
Upon completing the gas line connection, a small amount of air will be in the lines. When first lighting the
burner, it will take a few seconds for the lines to purge themselves of this air.
Once the purging is complete, the burner will light and operate as indicated in the instruction manual.
Subsequent lighting of the appliance will not require such purging unless the gas supply has been
disconnected.
2. Hold a lit long match or long butane lighter near the burner ports on top of the burner. For a
Natural Gas unit, turn on the ON/OFF valve slowly at the unit. For a LP unit, turn the valve in the LP
3.
4. To shut down the burner turn the burner control knob clockwise to the off position. Then turn
Note: The propane regulator in this appliance is equipped with a low flow protection device. Unless
the propane cylinder valve is opened before the appliance valve, the gas flow will be reduced resulting
in a very small flame. To reset this device, shut off the appliance valve, then the propane cylinder valve.
Next, diconnect the regulator adaptor from the tank and then reconnect. Follow the lighting procedure
ensuring the propane cylinder valve is opened before the unit is.
www.napoleongrills.com

Burner Assembly

Manual Gas
Valve (on/off)
If you do not follow these instructions exactly a fire or explosion may result causing
Keep face and body away from burner area when lighting.
1. Locate the manual gas control valve.
tank counter clockwise all the way and then turn on the ON/OFF valve slowly at the unit.
If the burner does not light within 10 seconds, turn the valve off and wait 5 minutes for any gas
to dissipate before repeating the procedure.
the gas off at the source (propane cylinder valve or natural gas supply valve).
N415-0359 JUN 12.18