Battery Charger - Askoll eS1 Mode D'emploi

BATTERY CHARGER

Batteries are charged using the specific charger
supplied (MOD. TVC202).
The charger is activated only when connected to the
mains with its cable and to the vehicle or to a battery
through the socket. Once connected, all leds will flash
for a few seconds, and then indicate the remaining
battery depending on the amount of leds lit.
The button MODE on the battery charger allows setting
research mode choosing between:
MAINTENANCE: press MODE until 2 leds blink (up
to 50), battery is charged until 50%. Now it is possible
to leave the battery unused for longer periods while
preserving battery life.
LONG LIFE (90% recharge): this mode is recommended in periods when the scooter is frequently used to obtain
the best and prolonged operation of the batteries. For maximum system efficiency, it is recommended to alternate
1 100% charge cycle every 10 90% cycles.
This procedure allows to obtain a high number of charge and discharge cycles of the batteries, maintaining a good
charge percentage performance over time.
To select this mode press MODE until 4 leds start flashing (up to 90).
MAX. CHARGE: default mode, press MODE until 5 leds blink (up to 100), battery is charged until 100%. In this
way there is maximum autonomy.
Charging time (eS - eS 25Km/h - eS
1 1
low battery).
Charging time (eS - eS EVOlution): from 1 to 6 hours (full charge starting from low battery).
3 3
eS_Rev02_EN.indb 41 eS_Rev02_EN.indb 41
BATTERIES AND RECHARGE
- eS 25Km/h - eS EVOlution): from 1 to 4 hours (full charge starting from
2 2 2
EN
EN
EN
EN
EN
41
15/07/2020 11:58:35 15/07/2020 11:58:35