Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NOTE: This is thermostatic remote control. The remote should be in the same room as fireplace and placed
on a flat surface. It must be placed away from the fire so the hot air will not blow on it and affect
thermostatic reading.
The communication frequency between the fire and remote has already been set
up. If you cannot use the remote with the fire, please follow instructions
Step.3b.34 to initiate this connection in point.
Standby for Remote Handset
3b.1 The screen shown to the right is when the remote handset is in
standby condition.
Turn on/off
3b.2 Press
to turn on the flame effect, turn off flame effect and heater
when in normal mode.
3b.3 Press
to turn on/off the flame effect under daily and weekly timer
mode.
Flame Effect
3b.4 Press
to enter the flame effect adjustment screen.
3b.5 Press the '←' and '→' button to select the 3 kinds of flame effect.
3b.6 Press the '+' and '-' button to select the 5 brightness of flame effect and OFF
settings.
Normal Mode
3b.10 Normal control mode is factory set. If it is not, then press
the logo
shows up at the upper right corner of the screen.
3b.11 Press the '+' and '-' button to adjust the setting temperature from 17℃ to
25℃ by 2 intervals.
3b.12 Press
button to turn on/off heat,
lower of the screen.
NOTE: It is normal for the fan heater to stop running for periods of time. This
happens because the room temperature is at or above the temperature set on the
remote control. The heater indicator will be turned off after 10s if you have the
flame ON. The heater indicator will stay ON if you use the heating function only.
Count Down Timer
NOTE: This setting is only for normal mode. It
after a set period of time.
3b.13 Press
to cycle through the settings from Off and 0.5 hours to 9 hours.
The timer logo and time will show on the screen. The heater must be in the
ON position.
button until
ON、 OFF will show at the
allows the appliance to go into standby
23
Publicité
Table des Matières
