Dimplex Vivente VVT75 Manuel D'utilisation page 7

Comfort$aver
This electric fire operates with Comfort$aver technology, which automatically adjusts the fan
speed and heater wattage to match the requirements of the room based on the thermostat setting.
Conventional electric heaters work by simply being fully on or off, which can result in swings from
slightly too warm to slightly too cold.
Comfort$aver operates such that once the room reaches the set point, the fan and heater will
continuously run at a low level, to maintain the desired room temperature providing a more
comfortable heating which results in up to an 11% energy saving.
If the temperature in the room rises significantly, i.e. sun coming through a window or the central
heating turns on, the heater will turn off and periodically turn back on to circulate the air around
the unit, until the room temperature drops and requires the heater to be constantly on again.
SmartSense
SmartSense detects activity or movement in a room and automatically switches on the flame
effect, without the need for you to touch the controls. SmartSense will also detect inactivity in a
room and after a certain period of time switch the product into standby mode. See Fig. 15 which
illustrates the detection zone for SmartSense.
When the fire detects no activity, it will switch itself off. You can choose either these periods of
time - 30 minutes or 3 hours.
SmartSense is deactivated for 3 minutes after the product is put into standby mode. This allows
you to leave the room after putting the product on standby, without triggering the SmartSense
function.
SmartSense has the following three settings:
"HOME" (via APP)
On this setting SmartSense will only switch the flame effect when it detects movement between
the hours of 5-11pm, so if you enter the room during the day the fire will not react. However in
the evening, your Dimplex fire will instantly switch on your flame effect – remembering your last
setting.
"24 Hr" (Default)
SmartSense will switch on the flame effect when it detects movement at any time during the day
or night. This is ideal for retail and commercial environments.
"OFF"
SmartSense can be switched off, which will allow the product to preform normally in every other
aspect
Controls
The unit can be controlled by:
• Onboard/Manual controls which are located on the upper right of the fireplace (See Fig. 16)
• Remote control – supplied
• App control. Using a dedicated App on your smart phone
Not all of the features, however, can be accessed by the on-board controls. To access the full
range of features, the smart phone App is required.
7