Practical Advice - ESYLUX AL S 230i Notice De Montage Et D'utilisation

Operating continuous lighting ON/OFF
Continuous light mode OFF disabled – Every time the
pressed, the light switches ON for 12 hours. Continuous light OFF enabled
– Pressing the
button is pressed again, the light will switch OFF for 12 hours. Press
the
button again to switch the light OFF – ON – OFF – ON.
NB: Pressing the
GB
mode and holiday mode functions. After the 12-hour „continuous ON/OFF"
period has expired, or if the
to automatic mode.
360° anti-creep protection ON/OFF (programming mode)
Deactivates the downward-facing 360° sensor to avoid the device
switching on accidentally. Press the
creep protection.
Focus LED ON/OFF (programming mode)
Press this button once to switch off the focus LED – press again to switch it
back on. The focus LED briefly lights up to indicate that it is active.
NB: When the focus LED is switched off, a signal is still acknowledged by two
flashes of the "blue mode" LED.
Alarm mode (programming mode)
If movement is detected, the detector switches ON for 1 second and OFF
for 1 second. This continues for 30 seconds (flashing phase). Then the light
switches to continuous mode for the rest of the on-period, or another alarm
phase is triggered if motion is detected. To cancel, press the
end the alarm function, press the
Holiday mode (programming mode)
This function activates the connected lighting for 1 to 8 hours once a
predefined light value has been reached, regardless of whether motion is
detected or not. Once this period of continuous lighting has elapsed, the
motion detector switches back to automatic mode. The process is repeated
every day.
Setting: one hour is added each time the holiday mode button is pressed.
The set number of hours is indicated by the blue mode LED. When the
holiday mode button is pressed for the first time, the blue mode LED lights
up for a prolonged period and is then briefly interrupted: this means 1
hour is set. When the holiday mode button is pressed for the second time,
the blue mode LED lights up for a prolonged period and is then interrupted
twice: this means 2 hours are set. This process continues up to a setting
of 8 hours. If the button is pressed for a ninth time the system returns to 1
hour.
12
button once switches the light ON for 12 hours. If the
button deactivates the special impulse mode, alarm
button is pressed, the detector will switch
button again to reactivate anti-
button.
RESET
Once the required number of hours has been programmed, close
button is programming mode to activate the function.
To cancel, press the
To quit holiday mode, press the
Reset
Resets the device to automatic mode. This cancels alarm mode, holiday
RESET
mode, impulse mode, test mode and the time setting.
Reset – in programming mode
Resets the device to the default settings. Cancels all values set by remote
control and resets all functions. The device operates according to the
preset factory settings (10 lux/2 min/max. electronic range).
Master X
This is used to activate the continuous lighting OFF function (see
Continuous lighting ON/OFF) and to cancel the time settings.
Electronic range adjustment
This function electronically increases the range by +15 % or decreases it
by -30 %. The
button. To
7 • PRACTICAL ADVICE
• Small animals, nearby trees or bushes moving in the wind may trigger the device.
• The detector's range can be dramatically reduced by objects moving towards it, rather
than parallel with it.
8 • DISPOSAL
NOTE: this device must not be disposed of as unsorted household waste. Used devices must
be disposed of correctly. Contact your local town council for more information.
button.
button.
RESET
NB: If the continuous lighting OFF function is to be used further, it must
be re-enabled.
button reinstates the basic settings.