Charging The Battery; Attaching The Belt Clip - Siemens Gigaset Micro 4000i Mode D'emploi

Press Keys:
4010/4015 Hold down the key on the underside of
the base station.
3010/3015 Hold down the paging-key
station until you hear signal tones.
3020/25 Select
ster handset
3030/35
4030/35
tion telephone and confirm with
3070/75 Press the LED – it will flash during regis-
4070/75 tration.
Non-Sie- To register at "GAP base stations" , follow
mens base the relevant operating instructions
stations (steps 2 and 3).

Charging the battery

Leave the handset for approx. 5,5 hours in
the charging unit to charge the battery, as
5,5
they are not charged when they leave the
factory. The charging status icon flashes on
the handset to indicate that the battery are
being charged:
See the appendix for a list of recommended battery.
G The battery heat up during charging. This is normal
and not dangerous.
G Opening the battery compartment unnecessarily
may cause the wrong charging status to be dis-
played.

Attaching the belt clip

Push the belt clip onto the back of the handset until the
lugs at the side click into place.
Preparing the handset
y
settings system settings
,
in the menu at the base sta-
on the base
regi-
and
OK
.
7