Rexel Momentum M510 Mode D'emploi page 4

f
e
a
b
c
Overview
a Indicator panel
b Pull-out bin
c Bin viewing window
d Safety symbols
e Paper feed slot
f On/Off switch
Please read and keep these
important safety instructions
For a full copy of the operating instructions, hints
& tips and troubleshooting guide, please visit
www.rexeleurope.com/support
The following symbol which is
found on the product indicates
you could be seriously hurt or
killed if you open the machine.
DO NOT OPEN.
4
d
c m
WARNING
Electrical shock hazard.
Do not open. No user
serviceable parts inside.
Refer servicing to qualified
service personnel.
• Only use the unit for its intended purpose.
• The unit must only be connected to a supply voltage
corresponding to the electrical rating shown on the unit.
• Unit should be connected to a socket outlet near the equipment
that is easily accessible.
• Do not connect multiple adaptors or use with an extension
cable.
• Failure to follow these instructions could result in damage/injury
and will invalidate your guarantee.
• Do not attempt to service or repair the unit yourself.
• If recycling, separate paper and credit card shreds.
• Do not use this unit if the cable or plug have been damaged.
• Care should be taken when moving equipment to avoid any
unleveled surfaces.
• Please read all the safety information and the instructions.
The manufacturer is not liable for cases of material damage or
personal injury caused by incorrect handling or non compliance
with the safety instructions. In such cases, the warranty will be
voided.
• The device is intended for use indoors. Never use outdoors.
• Keep the device away from moisture.
• Be vigilant at all times, and always be careful what you are
doing. Do not use electrical equipment if you are lacking in
concentration or awareness, or are under the influence of drugs,
alcohol or medication. Even a moment of inattentiveness can
lead to serious and injuries when using electrical equipment.
• Do not attempt to open, modify or repair the device. Do not
drop, puncture, break or expose to high pressure.
• Alterations to the device and technical modifications are not
permitted.
• Check the device and cable (and if applicable, the adapter) for
any damage before use. If there is any visible damage, a strong
odour, or excessive overheating of components, unplug all the
components immediately and stop using the device.
• Shredder must be disconnected from power source, if not used
for an extended period of time.
• Do not use spray cleaners or spray lubricants as these may
present a risk of flash fire.
Warning:
Sharp edges, do NOT touch cutters
Warning:
Moving parts, do NOT touch cutters
Never bypass the safety interlock (strictly forbidden &
dangerous, especially when unit is connected to a power source)