Setting A Programme; Starting A Programme - Electrolux EW6F5823ABM Notice D'utilisation

20 www.electrolux.com
5. Measure out the detergent and the
fabric conditioner.
6. Carefully close the detergent
dispenser.
Make sure that the flap does not cause a
blockage when you close the drawer.

11.5 Setting a programme

1. Turn the programme dial to select the
desired washing programme.
The indicator of the Start/Pause button
flashes.
The display shows an indicative
programme duration.
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options by
touching the related buttons.
If a selection is not possible
an acoustic signal sounds.

11.6 Starting a programme

Touch the Start/Pause button to start the
programme. It is not possible to start the
programme when the indicator of the
button is off and doesn't flash (e.g.
programme dial on a wrong position).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
11.7 Starting a programme with
the delay start
1. Touch the Delay Start button until the
display shows the desired delay time.
The related indicator comes on.
2. Touch the Start/Pause
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows .
3. Touch the Start/Pause
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause
again to start the new countdown.
11.8 The SensiCare System
load detection
After touching the Start/Pause
button:
1. The SensiCare System starts
estimating the weight of the load to
calculate the real programme
duration. During this phase the two
dots separating hours from minutes
are blinking
2. After about 15-20 minutes new cycle
duration is displayed.
The appliance automatically adjusts
the programme duration to the load
to achieve perfect washing results in
the minimum possible time.
button. The
.
button to
button
button to
button