Information For Installation - Electrolux EW6F5823ABM Notice D'utilisation

5. Remove the polystyrene protection from
the bottom. Put the appliance back into an
upright position.
7. Remove the three transit bolts and pull
out the plastic spacers.
We recommend that you
keep the packaging and the
transit bolts for any transport
of the appliance.

3.2 Information for installation

Positioning and levelling
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard
floor. The appliance must be levelled and
stable. Make sure that the appliance
does not touch the wall or other units and
there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
1
2
6. Remove the power supply cable and the
drain hose from the hose holders.
It is possible to see water flowing from the
drain hose. This is because the washing
machine has been tested at the factory.
8. Put the plastic caps, that you find in the
user manual bag, in the holes.
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
The inlet hose
CAUTION!
Make sure there is no
damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet
hose is too short. Contact
the service centre for a
replacement inlet hose.
ENGLISH 7