Emergency Drain; Frost Precautions; Troubleshooting - Electrolux EW6F5823ABM Notice D'utilisation

13.8 Cleaning the inlet hose and the valve filter

13.9 Emergency drain

If the appliance cannot drain the water,
carry out the same procedure, described
in 'Cleaning the drain pump' paragraph. If
necessary, clean the pump.

13.10 Frost precautions

If the appliance is installed in an area
where the temperature can reach values
around 0° C or drop below, remove the
remaining water from the inlet hose and
the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.

14. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
14.1 Introduction
The appliance does not start or it stops during operation.
1
2
3
20°
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
ENGLISH 27
45°