Emergency Drain; Frost Precautions; Troubleshooting - Electrolux EWF 1408 WDL2 Notice D'utilisation

24 www.electrolux.com
3.

12.8 Emergency drain

Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (8) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.

12.9 Frost precautions

If the appliance is installed in an area
where the temperature can be less than

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
4.
20°
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
• Check the tap - The appliance does
not fill with water properly.
• Check drain filter - The appliance
does not drain the water.
• Check the door - The appliance door
is open or not closed correctly.
45°