Télécharger Imprimer la page

Graco SnugRide Classic Connect 30 Front Adjust Manuel D'utilisation

Publicité

Liens rapides

To Remove Existing Harness Tongues and Buckle and Attach Replacement Buckle
You will receive ONE of
these Graco approved
replacement buckles.
Follow instructions for
proper installation.
4
Remove chest clip.
DO NOT DISCARD
the chest clip.
7
Slide NEW buckle onto harness straps
from the back to the front. Depending on
your buckle, the tongues may have "BACK"
written on the back of tongue. MAKE sure
not to twist harness straps.
10
Route the harness
thru the ribs .
SnugRide® Classic Connect™ 30 Front Adjust
Aprica A30 Buckle Replacement Guide
1
To loosen straps, lift lever
and pull harness straps.
5
Unbuckle harness
11
Remove harness
2
strap loops from
splitter plate.
by tilting top of
buckle down,
press top of
red button, and
pull tongues
out of buckle.
8
Re-attach chest clip.
MAKE sure not to
twist straps.
Re-insert straps back
onto splitter plate.
©2014 Graco PD265296E 7/14
3
Pull harness straps
through seat back
6
Remove and
discard tongues.
9
Re-insert straps through slots
in seat pad and seat back.
See carseat owner's manual
for proper height setting for
your child.
Turn page over to
fi nish the rest of
the assembly
Steps 12 to 17
for the buckle
replacement.
and seat pad.

Publicité

loading

Sommaire des Matières pour Graco SnugRide Classic Connect 30 Front Adjust

  • Page 1 SnugRide® Classic Connect™ 30 Front Adjust Aprica A30 Buckle Replacement Guide ©2014 Graco PD265296E 7/14 To Remove Existing Harness Tongues and Buckle and Attach Replacement Buckle Remove harness strap loops from splitter plate. You will receive ONE of these Graco approved replacement buckles.
  • Page 2 • Make sure the chest clip is properly threaded as shown Insert NEW tongues into buckle. in Step 8. In USA: Graco Children’s Products Any questions 3 Glenlake Parkway please contact us at : Atlanta, GA 30328 1-800-345-4109 • www.gracobaby...
  • Page 3 SnugRide® Classic Connect™ 30 réglage vers l’arrière Guide de remplacement de la boucle Comment retirer la boucle et les languettes existantes et installer la boucle de rechange Vous allez recevoir UNE de ces boucles de rechange Graco approuvées. Suivre les directives pour une installation adéquate.

Ce manuel est également adapté pour:

Snugride classic connect 30