Table des Matières
Publicité
OBJ_BUCH-3228-001.book Page 7 Thursday, December 14, 2017 2:55 PM
Product Description and
Specifications
Intended Use
The power tool is intended for bending plastic, stripping coats
of paint and heating shrink tubing. It is also suitable for solder-
ing and tinning, melting adhesive bonding and thawing water
pipes.
Technical Data
Heat Gun
Article number
Rated power input
Air flow
Temperature at the nozzle outlet
Temperature measurement accuracy
Weight according to EPTA-Procedure 01:2014
Protection class
1) The amount of air increases when the temperature rises from 50 °C to 300 °C. The speed of the fan is identical at both power settings
2) At an ambient temperature of approx. 20 °C.
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Noise/Vibration Information
Typically the A-weighted sound pressure level of the product
is lower than 70 dB(A).
Total vibration values a
(triax vector sum) and uncertainty K:
h
2
2
a
≤2.5 m/s
, K=1.5 m/s
.
h
Operation
Starting Operation
Observe the mains voltage! The voltage of the power
source must correspond with the data on the type plate of
the machine.
Creation of smoke during initial use
A coating protects the metal surfaces from corrosion ex-
works. This protective layer evaporates during initial use.
Switching On
Slide the on/off switch 2 upwards.
Switching Off
Slide the on/off switch 2 downwards into the 0 position.
GHG 18-60: After working at high temperatures for a
prolonged period, let the power tool cool down by
briefly running it at the 50 °C power setting before
switching it off.
Bosch Power Tools
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
10 Heat-shrinkable sleeve*
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
2)
Selecting a power setting
You can choose between different power settings using the
on/off switch 2:
GHG 18-60:
When changing from 50 °C to 300 °C, the speed and
The 50 °C power setting is suitable for cooling down a heated
workpiece or for drying paint. It is also suitable for cooling
down the power tool before putting it down or changing the
attachment nozzles.
1 Standing surface
2 On/off switch and power settings
3 Nozzle
4 Heat shield, removable (GHG 18-60)
5 Wide jet nozzle*
6 Glass protection nozzle*
7 Angle nozzle*
8 Reflector nozzle*
9 Reduction nozzle*
GHG 16-50
3 601 BA6 0..
W
1600
l/min
240/450
°C
300/500
±10 %
kg
0.52
/II
GHG 16-50
Power setting
300
500
GHG 18-60
Power setting
300
600
therefore the operating sound of the gun do not change.
English | 7
GHG 18-60
3 601 BA6 1..
1800
1)
1)
200
/350
/500
1)
1)
50
/300
/600
±10 %
0.52
/II
°C
l/min
240
450
°C
l/min
50
200
350
500
1 609 92A 3X4 | (14.12.17)
Publicité
Table des Matières
