Connecting The Drain Hose - Gree GTHCA-K6DNA1A/I Mode D'emploi

Fig. 21
Tighten the clamp until the screw head is less than 4 mm from the hose. (Fig.
22)
①- Metal clamp ②- Drain hose ③- Grey tape
Insulate the pipe clamp and the drain hose using heat insulation sponge. (Fig.
23)
①- Metal clamp ②- Insulation sponge
(1). When drain hose requires extension, obtain an extension hose
commercially available.
(2). After connecting the local drain hose, tape the slits of the heat insulation
tube.
(3). Connect the drain hose to the local drain pipe. Position the inner
connecting wire in the same direction as the piping.

5.4.3 Connecting the Drain Hose

(1). Connect the extension auxiliary pipe to the local piping.
(2). Prepare the local piping at the connection point for the drain pipe, as
shown in the installation drawings.
Note: Be sure to place the drain hose as shown in the diagram below, in a downward sloping
direction.
Fig. 22
24
Floor Ceiling Type Unit
Fig. 23