4MOMS cleanwater tub Manuel D'instructions page 14

WARNING
• This tub is designed to fit in most single- and double-basin
kitchen sinks and standard adult bathtubs. Ensure that the tub
is stable before placing baby in it. If the tub appears to be
uneven in a double-basin sink, it may be considered unsafe.
• Babies are most vulnerable to drowning when under 12
months old.
• Ideal bath temperature for babies is between 90° and 100° F
(32.2° and 37.8° C).
• For maximum safety, it is recommended that your home's hot
water heater be set at a temperature no higher than 120 °F (49
°C) at the faucet, as recommended by the American Academy
of Pediatrics.
• We recommend that you always check the water temperature
with your hand prior to placing the infant into the tub as an
added precaution.
• This product has a built-in thermometer that is intended to
display only the temperature of the water coming out of the
faucet. It is not intended to be used as a medical thermometer.
• Temperature Sensor (3) does not control the temperature of
the water.
26
WARNING
• Water entering tub must flow over Temperature Sensor (3) in
the Water Collection Area (4) for proper water temperature
measurement. It will not operate properly if the Temperature
Sensor (3) is not in contact with running water.
• Never run water directly into the Bathing Area (10) of the Tub.
• Water should not flow over the walls of the Water Collection
Area (4) and only pass through the trough into the Clean Water
Reservoir (5). Adjust water flow rate accordingly.
• If you see the message Err on the digital LCD display screen,
Temperature Sensor has malfunctioned. If the Err Code does not
go away after increasing the water temperature, discontinue
use and contact 4moms Customer Care.
• NEVER attempt to plug the Sidewall drain (8).
• This tub is equipped to work with the faucet water flowing
throughout bath time. Ensure that the water does not reach a
level that would jeopardize the safety of the baby.
• Tub is equipped with two Drain Holes (8-9) on the sidewall to
expel flowing water. Plugging the Newborn lower drain hole (9)
will raise the water level in the Bathing Area (10).
• Ensure that the water does not reach a level that would
jeopardize the safety of the baby.
ENGLISH
27