ENBIO S Mode D'emploi page 40

PROGRAM 134 o C
FAST
Type of load Unpacked
instru-
ments
Process tem- 134°C
perature
Pre-vacuum 1
number
Sterilisation 3,5 min
duration
Drying -
duration
Total
100g: 7 min
100g: 10min
process
ENBIO PRO
duration
Class S
*Ambient temperature can affect the process extension.
*The duration of the first process may be longer due to the need for the device to heat up
**PRION program is available only in ENBIO PRO.
The 134°C program is recommended for the majority of sterilised mate-
rials due to the short duration of the entire program. The 121
be used to sterilise all other materials that cannot be subjected to steri-
lisation at the temperature of 134
of 500 g for ENBIO S and 800 g for ENBIO PRO. The displayed time is ap-
proximate. The pre-vacuum time is updating and depends on the form
39
134 C 121 C PRION**
o o
Packaged Packaged Packaged
and and
non-pack- non-pack- non-pack-
aged tools aged tools aged tools
134°C 121°C
3 3
4 min 15 min
3 min 5 min
4 min 5 min
ENBIO ENBIO
PRO PRO
100g: 13 min 100g: 26 min 800g: 43 min
200g:18 min 200g: 31 min
ENBIO PRO ENBIO PRO
B B
C. Do not exceed a maximum weight
o
and weight of the charge.
When the device is turned on and
the display shows the start screen,
press the screen to go to the device
menu. From here you can execute
the Program, go to the Test, Infor-
mation menu, and the COUNTERS
menu.
Temperature programs with 121°C, 134°C and 134°C PRION for unpacked
and packaged loads and the 134°C FAST program for unpacked loads can
and
be selected via the program menu.
When the
134°C
3
18 min
5 min
B
C should
o
.
If the USB drive has not been inserted in the device, the USB symbol is not
displayed in the bottom right corner
of the screen, and a message about the missing USB drive is displayed.
The program data will not be saved. You can continue working without
saving the data on the USB drive by
pressing the
to insert the drive in the port and start the program from the beginning.
If you decide to continue working or the
selected, the screen will display a chart of pressure during the entire pro-
chamber is
the chamber is locked by turning the
lock knob clockwise, the display will
show the
dicating the chamber has been closed
correctly.
Now you can select the program by
pressing the symbol of the tempera-
ture you want to perform the
sterilisation in
The selected program is initiated by
pressing the corresponding symbol
field or stop working by selecting the
opened, the
symbol blinks. When
symbol, in-
or .
, field
. field has been