Options; Technical Support - Warranty - Extel MOMBO MR002C2 Guide D'installation Et D'utilisation

8. OPTIONS

• Extra monitor with intercom (MN MOMBO)
• Plug-in power supply (830218)
• All Extel electric catches
• All Extel electric locks
• All Extel motors

9. TECHNICAL SUPPORT - WARRANTY

Fault
• The monitor does not
light up
• Bad image and/or bad
sound
• Image is too bright
• Blue screen, no
ring tone
• The monitor does not
light
• The monitor rings
and then everything
jams
The latest version of the instructions in colour is downloadable from:
WARRANTY TERMS
The warranty does not cover: consumables (batteries, etc.) and damage caused by: incorrect use, incorrect instal-
lation, third party intervention, deterioration through physical impact or electric shock, dropping, or atmospheric
phenomena.
• Do not open the appliance as this will void the warranty.
• When returning the appliance for eventual servicing, protect the screen to avoid scratches.
• Only clean using a soft cloth, do not use solvents. The guarantee is void if parts have been dismantled. Before
cleaning, disconnect or power off the appliance.
GB6
Cause
• The monitor is not connected to
a power source
• Environment
• Wiring too short
• Position of the outside station
• Installation
• Reversed polarity
• Short circuit on the line
If required, our technical site is at your disposal: www.cfi -extel.com
This appliance has a parts and labour warranty in our workshops.
CFI EXTEL MOMBO - 10/2015
Solution
• Check that the adapter plug is correctly
fitted
• Check that the wires used are the correct
size and that the connection wires for the vid-
eophone are not in the same sheath as the
230V.
• Use at least 5 m of wire
• Do not expose the lens of the camera
directly to sunlight or to a reflective surface.
• Check the settings
• The wires connecting the monitor and the
outside station are reversed (1 and 2)
• Correct the connection
• Correct the connection and cut the power
supply for 10 seconds
www.cfi -extel.com