Fein WPO14-15E Mode D'emploi page 14

3 41 01 130 21 0.book Seite 14 Freitag, 18. Dezember 2009 7:47 07
en
14
Changing the tool.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Mounting the polishing tool (Figure 4).
Only press the locking button when the
motor is not running.
Press and hold the locking button.
Replace the used-up polishing tool or
insert a new one.
Press and hold the locking button.
Tighten the polishing tool.
Working instructions.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching ON and OFF (Figure 5).
First check that the power
WARNING
cable and power plug are not
damaged.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
:
Switching ON
Push the switch towards the front (I).
:
Switching OFF
Press the switch downward (0).
Fig. 4
Locking button
Fig. 5
On/Off switch
Polishing tool