Dexter 800AG2-125.5 Manuel D'instruction page 189

11. TRACEABILITY NUMBER /
SERIAL NUMBER
The Traceability Number/Serial Number will be showed in the label.
12. TROUBLESHOOTING
PROBLEM CAUSE
Machine does 1.Power cord not plugged in.
not start. 2.Power cord is damaged.
3.Circuit breaker is tripped.
4.Switch is locked at "OFF"
conditions.
Motor does 1. Voltage from power
not reach full. source.
2. Circuit is overloaded.
3. Motor burned out.
Motor stalls, 1. Switch is defective.
blows fuses, 2. Carbon brush is wornout.
or trips circuit 3. Voltage from source is
breakers. low.
4. Fuses or circuit breakers
are wrong size or defective.
Motor 1. Motor is overloaded.
overheats. 2. Grinding disc is being fed
into work too fast.
3. Air vents become
obstructed.
SOLUTION
1. Plug in cord.
2. Replaced at authorized
service center.
3. Reset circuit breaker.
4. Restart the tool.
1. Request a voltage check.
2. Test on a different circuit or
without anything else on circuit.
3. Have tool serviced and
request a voltage check.
1. Replaced at authorized
service center.
2. Replace at authorized
service center.
3. Request a voltage check.
4. Replace with a correct
circuit breaker or fuses.
1. Request a voltage check.
2. Feed grinding into work
slower.
3. Clean air vents.
188
FR
ES
PT
IT
EL
PL
UA
RO
EN