Dexter 800AG2-125.5 Manuel D'instruction page 185

Overview
1. Paddle
2. Side handle
3. Protective cover (grinding125mm)
4. Guard locking lever
5. Gear box
6. Lock button
7. Spanner
8. External flange with thread
9. Internal flange
10. Safety interlock
11. Protective cover (grinding115mm)
Mounting the Auxiliary Handle
The side handle can be fitted to the left, right of the unit. Select the position
which gives the most comfortable and safe use.
CAUTION:
Always be sure that the side grip is installed securely before operation.
During operation, keep one hand on the rear handle and the other on the side
handle.
Installing or moving protective cover
WARNING: Ensure the angle grinder is switch off and unplugged from the
mains.
Depending on whether your operation is cutting or grinding, select the correct
protective cover. Failure to use the right cover for operation could result in injury.
When using a grinding or cutting-off wheel, the protective guard must be fitted
on the tool so that the closed side of the cover always points toward the operator.
Install the guard: release the lock lever of the guard and insert it on the gear head,
and turn/adjust in any desired position for maximum performance, then close the
lock lever. Make sure that the fastening lever is properly locked after setting the
guard.
To remove the protective cover, follow the installation procedure in reverse.
The protective cover can be turned to a desired angle, but not more than 45° on
left side or right side.
184
FR
ES
PT
IT
EL
PL
UA
RO
EN