Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FR
arm to allow you to resist kickback forces. Always use auxiliary handle,
if provided, for maximum control over kickback or torque reaction
ES
during start-up.
The operator can control torque reactions or kickback
forces, if proper precautions are taken.
PT
b) Never place your hand near the rotating accessory.
kickback over your hand.
IT
c) Do not position your body in the area where power tool will move if
EL
kickback occurs.
Kickback will propel the tool in direction opposite to the
wheel's movement at the point of snagging.
PL
d) Use special care when working corners, sharp edges etc. Avoid
bouncing and snagging the accessory.
UA
have a tendency to snag the rotating accessory and cause loss of control
or kickback.
RO
e) Do not attach a saw chain woodcarving blade or toothed saw blade.
Such blades create frequent kickback and loss of control.
EN
Safety Warnings Specific for Grinding and cutting-off Operations:
a) Use only wheel types that are recommended for your power tool and
the specific guard designed for the selected wheel.
power tool was not designed cannot be adequately guarded and are
unsafe.
b) The grinding surface of centre depressed wheels must be mounted
below the plane of the guard lip.
projects through the plane of the guard lip cannot be adequately
protected.
c) The guard must be securely attached to the power tool and
positioned for maximum safety, so the least amount of wheel is
exposed towards the operator.
broken wheel fragments and accidental contact with wheel and sparks
that could ignite clothing.
d) Wheels must be used only for recommended applications. For
example: do not grind with the side of cut-off wheel.
wheels are intended for peripheral grinding, side forces applied to these
wheels may cause them to shatter.
e) Always use undamaged wheel flanges that are of correct size and
Accessory may
Corners, sharp edges or bouncing
Wheels for which the
An improperly mounted wheel that
The guard helps to protect operator from
Abrasive cut-off
179
Publicité
Table des Matières
