ECOVACS ROBOTICS DEEBOT 500 Manuel D'instructions page 8

1. Important Safety Instructions
This device complies with Part 15 of the FCC Rules / Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement Caution: To maintain
compliance with the FCC's RF exposure guidelines, place the product
at least 20cm from nearby persons.
To ensure compliance, operations at closer than this distance is not
recommended.
This device contains licence-exempt transmitter(s)/receiver(s)
8
EN
that comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions:
1) This device may not cause interference.
2) This device must accept any interference, including interference
that may cause undesired operation of the device.
To disable Wi-Fi module on DEEBOT, turn the robot's Bottom Power
Switch ON. Place the robot on the Charging Dock making sure the
Charging Contacts on DEEBOT and the Charging Dock Pins make a
connection. Press and hold the AUTO Mode Button on the robot for
10 seconds until DEEBOT emits 3 beeps.
To enable Wi-Fi module on DEEBOT, turn the robot's Bottom Power
Switch OFF and then power ON. The Wi-Fi module is turned on when
DEEBOT is restarted.