Place the connecting strip (30) in its original position in the lower part of the cabinet.
Cabinet door installation
Align the door with the cabinet, connect the earthing lead to the door and mount the door to the
cabinet using 2 fasteners.
Do not push the compressor all the way to the back of the cabinet as it may
permanently damage the dryer.
DK50 2x4VR/110S (Fig. 3-B):
Opening the upper cover
Open the lock by turning with a screwdriver as shown in the pictogram and pick up using the
handle.
The gas springs will keep the cover open.
Be careful not to pinch your fingers when closing the cover on the cabinet.
Always lock with the quick releases after closing the cover on the cabinet!
Removal of the front panel on the cabinet
Remove the door held by 4 (M5) fasteners and disconnect the earthing lead.
Compressor placement
Insert the compressor with dryer into the cabinet so that the dryer fan fits into the cooling tunnel
opening in the cabinet. Check the positioning of the compressor in the cabinet against Fig. 6
Do not push the compressor all the way to the back of the cabinet as it may
permanently damage the dryer.
Cabinet door installation
Attach the door to the cabinet and connect the earthing lead to the door. Install the door on the
cabinet and mount using the 4 fasteners.
NP-DK50 4VR 50, DK50 2x4VR 110-MD-6_01-2022
28
INSTALLATION
01/2022