Care And Cleaning - Dualit DDK6 Mode D'emploi

USING YOUR KETTLE
SWITCHING ON
• Remove the kettle from the
power base before attempting to
pour.
• When filling or carrying the
kettle, do not tilt it backwards, as
this may allow water to pass
through the steam tube onto the
control area. Should this happen,
the kettle must be allowed to dry
before reuse.
• To avoid the risk of splashing,
wait 10 seconds to allow the
water to settle then pour slowly
and do not over-tilt the kettle.
W W A A R R N N I I N N G G : : I I F F T T H H E E K K E E T T T T L L E E H H A A S S J J U U S S T T
B B O O I I L L E E D D , , I I T T W W I I L L L L B B E E F F U U L L L L O O F F S S T T E E A A M M , ,
W W H H I I C C H H W W I I L L L L E E S S C C A A P P E E A A S S S S O O O O N N A A S S
T T H H E E L L I I D D I I S S O O P P E E N N E E D D . .
BOIL DRY
• Do not switch the kettle on
unless it contains at least one cup
of water.
Misuse of this kind will shorten
the life of the kettle.
• If the kettle is accidentally
switched on when it does not
contain sufficient water, a boil-dry
device will automatically switch it
off.
Wait until the kettle has cooled
down before refilling. Take
caution as the lid may be hot and
the water may spit as it touches
the kettle base.
8
SERVICING

CARE AND CLEANING

• Switch the kettle off (lift it from
the power base), unplug the
power base from the wall socket,
and let the kettle cool down
completely before cleaning. Wipe
the outside and inside surfaces of
the kettle with a damp cloth.
• If necessary, you may use a little
household detergent. To clean the
filter, see "Water filter" below.
• If you use detergent inside the
kettle, rinse thoroughly afterwards
to remove all traces.
• Ensure that all connectors and
sockets are kept dry.
• Do not immerse the kettle or
power base in water or any other
liquid.
• Do not use harsh or abrasive
cleaners or solvents.