Before Use - Dualit DDK6 Mode D'emploi

SAFETY PRECAUTIONS
• Unplug the power base from the
wall socket when not in use,
before moving and cleaning.
• Allow the kettle to completely
cool before cleaning and storing.
• Ensure that the lid is fully closed
before switching the kettle on,
otherwise it may not properly
switch off.
• Ensure that the kettle is correctly
placed onto the power base
before switching on.
• Do not fill above the max mark
on the water level indicator.
• Remove the kettle from its power
base before filling or pouring.
• Use the kettle only with the
powerbase supplied & vice versa.
• C C A A U U T T I I O O N N : : Do not operate the
kettle on an inclined plane. Do
not operate the kettle unless the
element is fully immersed. Do
not move while the kettle is
switched on.
• C C A A U U T T I I O O N N : : To prevent damage to
the appliance do not use alkaline
cleaning agents when cleaning,
use a soft cloth and a mild
detergent.
• Do not place the kettle, power
base, or mains lead on or near
any hot surface, hot hob or gas
burners.
• Do not use the kettle for any
purpose other than heating
water.
• Do not operate any appliance
with a damaged lead or plug, or
after the appliance malfunctions,
or has been damaged in any
manner.
If the mains lead is damaged, it
must be replaced by a special
cordset available from Dualit
helpline: + 44 (0) 1293 652 500
• For household use only.
SAVE THESE
INSTRUCTIONS
5

BEFORE USE

• Remove all packaging from the
kettle and its power base.
• Before using the kettle for the first
time, or if it has been out of use
for a long time, fill to the max
mark and boil, then discard the
boiled water and rinse the kettle
out with fresh cold water.
• Check that the voltage marked on
the appliance corresponds with
the supply voltage.
• N N O O T T E E : : Any plug cut from power
supply cord should be disposed of
immediately. Inserting any cut off
plug into a 13A socket-outlet is
hazardous.
• Never use the plug without the
fuse cover fitted. Ensure
replacement fuse is the same
current value as original.
• Replacement fuses are available
from Dualit and should be ASTA
approved to BS 1362.
GB