Visualisation And Signalling Using Led - V2 Easy Manuel D'utilisation

VISUALISATION AND SIGNALLING USING LED

A row of 8 red leds is fitted to the card, via which all the useful signals
for installation and usage are controlled.
During the normal running of the control unit (NOT at the programming
stage), the meaning of each led can be found in the following table:
LED OFF
On the start /up terminal,
1. start / up
the contact is open
On the open /stop
2. open / stop
terminal, the contact is open
On the down terminal, the
3. auto / down
contact is open
On the photo terminal, the
4. photo
contact is open
On the edge terminal, the
5. edge
contact is open
On the fire terminal, the
6. dm / fire
contact is open
7. light / canc -
8. motor / test
The motor is not activated
/ error
* Operating cycle: the 7 leds (light / delete) switch on
following the logic below:
• Led off: control unit off
• Flashing light led at 2 Hz: opening phase
ON
On the start /up terminal,
the contact is closed
On the open / stop
terminal, the contact is
closed
On the down terminal, the
contact is closed
On the photo terminal, the
contact is closed
On the edge terminal, the
contact is closed
On the fire terminal, the
contact is closed
-
The motor is activated
• Permanent led: control unit off with shutter open (if the
• Flashing light led at 4 Hz: closing phase
15
FLASHING led (combined with led 8)
Led 8 is OFF or ON
Start command received
from remote control
Stop command received
from remote control or start
aborted due to stop being on
Down command received
from remote control
Start aborted due to inter-
rupted photocell detection
Start aborted due to pressed
edge detection
Start aborted due to fire
alarm being on
Light command received from
remote control or opening
cycle* phase indication or
remote control codes erasure
timer is on for automatic closing, the led turns off
briefly, every half a second)
Led 8 is BLINKING
Writing in flash at the end
of the programming is failed
-
-
Photocell test is failed
Edge test is failed
-
Remote control codes
erasure is failed
Error indication