Switch And Pilot Arc Plugs - ESAB PT-27 Manuel D'instruction

sEctIoN 4
4.5

sWItch aND pIlot arc plugs

WarNINg
WHITE SWITCH LEADS (2)
FROM TORCH SWITCH
SWITCH PLuG
P/N 2062336
STRIP INSuLATION 1/4" (6.4 mm)
a. sWItch plug
CHROME PLATED TERMINAL
bRASS TERMINAL
figure 4-4. switch and pilot arc plug removal/replacement
Do Not INtErchaNgE thE torch sWItch plug aND thE pIlot
arc plug. If It BEcoMEs NEcEssarY to rEMovE thEsE plugs,
MakE surE thE sWItch plug (p/N 2062336) Is attachED to thE
tWo WhItE sWItch lEaDs aND thE pIlot arc plug Is attachED
to thE Black lEaD WIth thE BluE juMpEr WIrE.
INtErchaNgINg thEsE plugs MaY crEatE aN uNsafE coNDItIoN
that coulD causE ElEctrIc shock aND BurNs.
STRAIN RELIEF
TubING - P/N 055800079)
bLuE JuMPER
PILOT ARC PLuG
B. pIlot arc lEaD aND plug
(oN torch assEMBlY 21620)
CHROME PLATED TERMINAL
bRASS TERMINAL
*PILOT ARC PLuG
*TORCH ASSEMbLY 0558000487 uSES A RING CONNECTOR IN PLACE OF
THIS PLuG (REFER TO FIGuRE 5-1)
bLACK PILOT ARC LEAD
(ATTACH TO CHROME PLATED TERMINAL)
STRAIN RELIEF TubING
P/N 21622
80
MaINtENaNcE
bLACK PILOT ARC LEAD
STRAIN RELIEF
TubING - 21622
bLuE JuMPER
(SEE bELOW)
Do Not strIp INsulatIoN froM
thEsE thrEE WIrEs