Waeco MagicComfort MSH50 Instructions De Montage Et De Service page 24

_MSH50_MSH501.book Seite 24 Donnerstag, 13. August 2009 2:48 14
Installing the seat heater
Note
I
To bridge the stitching recesses or the cross braces with which the
seat cover is additionally secured to the foam core, a recess is pro-
vided on the heating element of the seat surface.
Depending on the seat, guide this area through the stitching recess
(fig. a, page 5) or place this area through the recesses in the tunnel for
the cross braces.
Fasten the heating element using double-sided adhesive tape to prevent
it sliding on the foam core.
Ensure that no creases or kinks form.
Installing the heating element for the backrest
Open the lower area of the backrest cover (fig. b, page 5).
Push the heating element into the gap between the seat cover and the
seat cushion (fig. c, page 5).
Fasten the heating element using double-sided adhesive tape to prevent
creases.
Note
I
The heating surface only needs to extend approx. 30 – 35 cm
above the seat, as the driver, when sitting normally, leans against
this area only.
If the seats are equipped with side airbags, then there is a prede-
termined breaking point in the cover fabric. The seat cover must
therefore not be pulled tightly or slip out of place.
Installing the seat
Lift the seat into the vehicle.
Secure the vehicle seat with the fastening screws.
24
MagicComfort MSH50, MSH501