Waeco MagicComfort MSH50 Instructions De Montage Et De Service page 20

_MSH50_MSH501.book Seite 20 Donnerstag, 13. August 2009 2:48 14
Safety and installation instructions
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 8, page 3) or a voltmeter (fig. 1 9, page 3).
Test lamps with an illuminant (fig. 1 12, page 3) take up voltages which
are too high and which can damage the vehicle's electronic system.
When making electrical connections (fig. 3, page 4), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulat-
ing tape, for example to existing cables.
Observe the following instructions when using the seat heater:
Do not place any sharp or heavy objects on the seat, as the seat heater
could otherwise be damaged.
Persons with an impaired sensitivity to heat should only operate the seat
heater at level I.
Do not place any heat insulating objects, such as blankets or coats, on the
seat when the seat heater is switched on.
The seat heater can be damaged by fluids spilt on the seat.
Never switch the seat heater on when it is wet.
20
MagicComfort MSH50, MSH501