Functional Description Of The Equipment; Tips And Needles Kits - Sagola X 4100 Serie Manuel D'utilisation

26/27

7. Functional Description of the Equipment

The SAGOLA gun model X 4100 series (Gravity, Pressure and Suction) can be used for applying
appropriately diluted products (paints, lacquers, varnishes, adhesives, etc.), used widely in the
automotive industry, timber industry, plastics, etc.
The SAGOLA gun model 4100 Xtreme Ceramic can be used for spraying highly abrasive and high
micronage products, used widely in the Construction, Industry in general (structural, bodyshop
industry, ceramics, vitrified enamels, etc.)
Compressed air for spraying is connected to the air input connector under the gun grip.
In the gravity or suction version; the product to be applied is placed in the cup provided for this
purpose, from which it flows by gravity or suction to the fluid tip and is then mixed with spraying air in
a way that can be controlled from outside the air nozzle.
In the pressure version; the product to be applied is placed in the pressure tank (hereinafter
Reboiler) or using a pressure pump. From here it flows through a hose to the fluid tip and is them
mixed with spraying air in a way that can be controlled from outside the air nozzle.
When the trigger is pulled back to the first position, it engages the air valve stem, opening this and
allowing air to flow through.
When the trigger is pulled back fully, the product needle is retracted, allowing the product to flow out.
This is then sprayed in the form of a fan.
When the trigger is released, the needle returns to its initial position, first closing off the product
outlet and then the air valve and application stops.

8. Tips and Needles Kits

SAGOLA S.A. supplies Nozzle Kits and Tip and Needle Kits of different
sizes for a variety of different applications. In order to replace these,
proceed as follows:
With the gun fully depressurised, remove the air nozzle. Remove the product regulator with the
spring and the spring stop and extract the needle to be replaced. Remove the tip with the wrench
supplied.
Fit the new tip and tighten. Now fit, in this order, the new needle, the spring and spring stop and the
product regulator. Lastly, fit the appropriate air nozzle.
There are Tip + needle Kits:
ø 0.80
ø 1.00
ø 1.20
ø 1.30
ø 1.40
ø 1.60
ø 1.60S
ø 1.80
ø 2.00
ø 2.20
ø 2.50
ø 2.80
ø 1.20
ø 1.30
ø 1.40
ø 1.50
ø 1.80
ø 2.20
ø 2.50
ø 2.80
Gravity Pressure
ENGLISH
Suction Ceramic