Sagola X 4100 Serie Manuel D'utilisation page 29

28/29
· Pressure version: When assembling the
equipment, make sure to connect the air hose to
air conduits (1) and the product hose to the
product conduits (2). Regulate product pressure
to the gun by applying product pressure until this
fails from 15 to 20 cm. from the gun, depending
upon the product to be applied (see Fig.3).
Adjust the air pressure in hte network regulator
in order to compensate for any pressure drop in
the network (estimated at 0.6 bar for each 10 m.
of hose).
Adjust the air pressure in the air nozzle by
operating the flow regulator until the required
quality of finish is obtained (better finishes are
not obtained with higher spraying pressures and
these lead to lower performance and worse
product transfer).
Position the air nozzle spraying orifices appropriately (when an imaginary
line is drawn through the 2 lugs (see Fig.4), this must be parallel or perpendi-
cular to the floor) Fully close the product regulator by turning it clockwise (see
Fig.5). Turn the product regulator until the "0" coincides with the arrow (see
Fig.6); and perform the desired application test, adjusting the product and
fan regulators (see Fig.7) and range as follows:
Fig.4
Open the product regulator until the appropriate amount of product comes out. Now you have the
maximum spraying width (spraying pattern). You can reduce this according to your needs by closing
the spray width regulator.
Please be sure that you put the spray gun properly by keeping its perpendicularity to the piece to be
painted in order to achieve the maximum transfer of the sprayed product and obtain the best
finishing quality.
18-20 cm
Fig.5
ENGLISH
Fig.6
Fig.3
Fig.7