Operation; Initial Operation; Operating Noises - Klarstein VINOVILLA DUO79 Mode D'emploi

OPERATION

Initial operation

Plug in and switch on the cellar by pressing on the power button for a few seconds.
When you use the wine cellar for the first time (or restart the wine cellar after having it
shut off for a long time), there will be a few degrees variance between the temperature
you have selected and the one indicated on the LED readout. This is normal and it is
due to the length of the activation time. Once the wine cellar is running for a few hours
everything will stabilize.

Operating Noises

To reach the desired temperature settings, VINICOLE wine cellars, like all wine cellars
operating with com- pressors and fans, may produce the following types of noises.
These noises are normal and may occur as follows:
• Gurgling sound - caused by the refrigerant flowing through the appliance's coils.
• Cracking/popping sounds - resulting from the contraction and expansion of the
refrigerant gas to produce cold.
• Fan operating sound - to circulate the air within the wine cellar.
• An individual's perception of noise is directly linked to the environment in which the
wine cellar is located, as well the specific type of models. The appliance is in line
with international standards for such appliance. Klarstein will always do its utmost
to satisfy its customers but will not retake possession of the goods due to complaints
based on normal operating noise occurrences.
Before loading and plugging your wine cellar
The location you have selected for your wine cellar should:
• be unencumbered and well ventilated;
• be well away from any heat source and direct sunlight;
• not be too damp (laundry, pantry, bathroom etc.);
• have a flat floor;
• have a standard and reliable electricity supply (standard socket to country
standards, linked to the ground), it is NOT recommended to use a multi-socket or
extension lead;
• have a surge protector fitted to the electrical outlet;
• away from the microwave oven. Certain microwave ovens do not have wave
interference shield. When placed within 1 meter vicinity of the wine cabinet, they
may affect the operation of the wine cabinet.
• This model is built-in type or free standing.
• The wine cellar should be placed where the ambient temperature is between 5ºC
to 35 ºC. If the ambient temperature is above or below this range, the performance
of the unit may be affected. Placing your unit in extreme cold or hot conditions may
cause interior temperatures to fluctuate. The ideal range of tem- perature may not
be reached. (See Climate Class at the end of this manual).
EN
27