Klarstein VINOVILLA DUO79 Mode D'emploi page 25

• This wine cellar is front venting but is not designed to be fully integrated behind a
joinery door.
• This appliance requires at least 5 mm clearance on both sides and top, 30 mm
clearance at the rear, to facilitate installation, removal, servicing and ventilation.
• This unit draws air from the rear and expels through the metal grid under the door at
the front.
• "Built in" wine cellars have a power switch located on the control panel so power
point location is not critical.
• The unit requires a standard 220 Volt/10 Ampere power point. (Or according to
different countries specifications).
• The power cord is 2.0 m in length and is fixed on the right side at the back when
looking from front of cabinet.
• As with most appliances of today, the wine cellar has sensitive electronic
components which are susceptible to damage through lightning and electricity
supply faults. It is therefore advised to use a power surge protector to avoid
problems of this nature.
• Air vent within the joinery must be provided for the appliance (front venting).
EN
25