Before Putting The Machine Into Operation - Ferm BGM1003 Traduction De La Notice Originale

EN
Wear ear and eye protection
wear a dustmask
Keep bystanders away
The product is in accordance with the
applicable safety standards in the
European directives.
Special safety instructions
• The following points need to be checked:
• Do the connecting voltage of the machine
correspond with the mains voltage.
• Are the mains lead and the mains plug in a
good condition; strong, without ravels or
damages.
• For functional reasons the turning parts of this
machine are not covered. Therefore it is of
utmost importance to be careful. Hold the
workpiece firmly, to prevent it from slipping
from your hands. Never touch the sanding
surfaces of a working machine with your
hands.
• Avoid the use of long extension cables.
Before you operate the machine:
• Always keep the mains cable away from
moving parts of the machine.
• Use safety goggles.
• Use a dust mask.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
6
the wall outlet.
Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important
that it is correctly destroyed and replaced by
an approved BS1363/13A fused plug and that
the following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
• b lue neutral
• b rown live
As the colours of the wires in the mains cable
of the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
• T he wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
• T he wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes and
verticiliosis in the collector.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch
• Smoke or stench of scorched isolation
3. Before putting the machine
into operation
Installation
Avoid the use of long extension cables. Do not
forget to leave enough space around the machine
for the workpieces to be sanded.
Assembly
• Put the machine frame on its head and press
the four rubber stops into the foot of the frame.
• Machine frame, aluminium disc (10) and work
plate (12) are supplied in separate packaging.
• Push the aluminium disc on the shaft and
fasten the disc with the socket bolt in the side
. When using a cable
2