Connecting The Appliance To The Power Supply; Electrical Connections - Zanussi ZBC40440 Notice D'utilisation

CONNECTING THE APPLIANCE TO THE POWER SUPPLY

• The electrical outlet should be readily accessible so that the unit can be
unplugged easily in an emergency. Or it should be possible to isolate the
oven from the supply by incorporating a switch in the fixed wiring in
accordance with the wiring rules.
• The socket should not be positioned behind the cupboard.
• The best position is above the cupboard, see (A).
If connection is to be made to position (A), remove the clip from position 15 on the
rear of the oven (see page 8) and use the clip to secure the power supply cord to the
top of the housing unit (see page 33).
When not connecting the power supply cord to position (A), the power supply cord
should be routed under the oven.
• Connect the appliance to a single phase 230 V/50 Hz alternating current via a
correctly installed earth socket.
The socket must be fused with a 16 A fuse.
• The power supply cord may only be replaced by an electrician.
• Before installing, tie a piece of string to the power supply cord to facilitate connection to point (A) when the appliance is being
installed.
• When inserting the appliance into the high-sided cupboard, DO NOT crush the power supply cord.
• Do not immerse the power supply cord or plug in water or any other liquid.

ELECTRICAL CONNECTIONS

WARNING:
THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should this
safety measure not be observed.
If the plug that is fitted to your appliance is not suitable for your
socket outlet, you must call your local ZANUSSI service agent.
34
(A)
www zanussi com