Mounting The Table; Installing Bevel Scale Indicator - RIDGID BS1400 Manuel Du Propriétaire

Mounting the Table

1. From the loose parts find the following items:
1 Table
2 Knobs
2. To mount table, remove table insert and table pin from
the table. Guide sawblade through slot in table and
place table screws into trunnions. Attach and lock with
lock knobs.

Installing Bevel Scale Indicator

1. From the loose parts find the following items:
1 Pointer
1 Screw Pan Head M5 x 0.8-6
2. Insert screw through the slot in the pointer and into the
trunnion support bracket. Tighten
WARNING: Unit is shipped with blade installed. Do
not plug in or operate unit unless the blade is
adjusted and aligned per section titled "Changing
Blades".
3. Replace table insert and table pin.
4. Transportation and handling may have caused some
fasteners to loosen. Before operating, check all
screws, bolts and nuts to make sure they are snug.
Operate machine only after reading the entire manual
including blade tracking, blade guide adjustments, and
safety rules.
Screw Pan Head
M5 x 0.8-6
15
Pointer
Trunnion
Support
Bracket