Caution On Lithium-Ion Battery - HIKOKI DB 3DL2 Mode D'emploi

Masquer les pouces Voir aussi pour DB 3DL2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
English
5) Battery tool use and care
a) Recharge only with the charger specified by
the manufacture
A charger that is suitable for one type of battery
pack may create a risk of fire when used with
another battery pack.
b) Use power tools only with speclflcally
designated battery packs.
Use of any other battery packs may create a risk of
injury and fire.
c) When battery pack Is not In use, keep It away
from other metal objects llke paper cllps,
coins, keys, nails, screws, or other small metal
objects that can make a connection from one
te
mlnal to anothe
Shorting the battery terminals together may cause
burns or a fire.
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If
contact accldentally occurs, flush with water. If
liquid contacts eyes, additionally seek medical
help.
Liquid ejected from the battery may cause irritation
or burns.
6) Service
a) Have you
power tool se
epair person using only identical replacement
parts.
This will ensure that the safety of the power tool is
maintained.
PRECAUTION
Keep children and Infirm persons away.
When not In use, tools should be stored out of reach
of children and Infirm persons.
PRECAUTIONS FOR CORDLESS DRIVER DRILL
1. Always charge the battery at a temperature of 10 -
40℃ • A temperature of less than 10℃ will result in
over charging which is dangerous. The battery cannot
be charged at a temperature higher than 40
The most suitable temperature for charging is that of
20-25'C.
2. When one charging Is completed, leave the charger for
about 15 minutes before the next charging of battery.
Do not cha「ge more than two batteries consecutively
3. Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
4. Never disassemble the rechargeable battery and
charger.
5. Never short-circuit the rechargeable battery. Short­
circuiting the battery will cause a great electric current
and overheat. It results in burn or damage to the
battery.
6. Do not dispose of the battery in fire.
If the battery Is burnt, it may explode.
7. When drilling in wall, floor or ceiling, check for buried
electric power cord, etc.
8. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery life
becomes too short for practical use. Do not dispose of
the exhausted battery.
9. Using an exhausted battery wlll damage the charger.
10. Do not insert object into the air ventilation slots of the
charger.
Inserting metal objects or Inflammables into the
charger air ventilation slots will result in electrical
shock hazard or damaged charger.
8
『·
『·
viced by a qualified
C.
°

CAUTION ON LITHIUM-ION BATTERY

This battery is exclusively for the driver drill. Never use
with any other heavy-duty power tools (i.e. Circular saw,
Reciprocating saw, Disc grinder and Blower, etc.).
To extend the lifetime, the lithium-ion battery is equipped
with the protection function to stop the output.
In the cases of 1 and 2 described below, when using this
product, even if you are pulling the switch, the motor may
stop. This is not the trouble but the result of protection
function.
1. When the battery power remaining runs out, the motor
stops.
In such case, charge it up immediately
2. If the tool is overloaded, the motor may stop. In this
case, release the switch of tool and elimlnate causes
of overloading. After that, you can use it again.
Furthermore, please heed the following warning and
caution.
WARNING
In order to prevent any battery leakage, heat generation,
smoke emission, explosion and ignition beforehand,
please be sure to heed the followlng precautions.
1. Make sure that swart and dust do not collect on the
battery.
0 During work make sure that swarf and dust do not fall
on the battery.
O Make sure that any swart and dust falling on the power
tool during work do not collect on the battery.
O Do not store an unused batte
to swart and dust.
O Before storing a battery, remove any swart and dust
that may adhere to It and do not store it together with
metal parts (screws, nalls, etc.).
2. Do not pie「ce battery with a sharp object such as a
nail, strike with a hammer, step on, throw or subject the
battery to severe physical shock.
3. Do not use an apparently damaged or deformed
battery.
4. Do not use the battery in reverse polarity.
5. Do not connect directly to an electrical outlets or car
cigarette lighter sockets.
6. Do not use the battery for a purpose other than those
specified.
7. If the battery charging falls to complete even when a
specified recharging time has elapsed, Immediately
stop further recharging.
8. Do not put or subject the battery to high temperatures
or high pressure such as into a microwave oven, dryer,
or high pressure container.
9. Keep away from fire immediately when leakage or foul
odor are detected.
10. Do not use in a location where strong static electricity
generates.
11. If any foul odor, overheating, discolor, deformation,
and/or other irregularities are detected during
use, charging and storage of the battery charger,
immediately remove it from the equipment or battery
charger, and stop use.
CAUTION
1. If liquid leaking from the battery gets into your eyes,
do not rub your eyes and wash them well with fresh
clean water such as tap water and contact a doctor
lmmedlately.
If left untreated, the liquid may cause eye-problems
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
y in a location exposed

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Db 3dl2hlz

Table des Matières