Cabling - Dynacord D 11A Mode D'emploi

13 O
UTPUT CONNECTOR FOR AUDIO SIGNAL
This electronically balanced output
provides the carried through audio
signal from the LINE IN connector.
It can be used to feed additional
external equipment (e.g. an addi-
tional D 11A) with the identical in-
put signal.

2.2 Cabling

For connecting audio signal sources to the D 11A, we rec-
ommend using cable with balanced XLR-type or stereo
phone plug connectors. Using balanced cable reduces the
risk of sound degradation resulting from interference.
However, make sure to mind the pin-assignment as shown
below. Original DYNACORD cable from our accessory pro-
gram will always comply with this pin-assignment.
Illustration 2-1: Balanced and unbalanced phone plug
BALANCED
UNBALANCED
Cable
2 HOT (+)
2
3 COLD (-)
3
1
1 SHIELD
Cable connection phone to XLR-type, unbalanced
shield
Cable connection phone to XLR-type, balanced
+
hot
shield
Standard phone-type, balanced
+
hot
shield
(LINE THRU)
SHIELD COLD
HOT
SHIELD
HOT
+
hot
2
-
cold 3
1
-
cold
2
3
1
-
cold
14 O (MASTER OUT)
UTPUT CONNECTOR
The output connector provides the
Master Signal (Line+Mic+Aux) for
"carrying through" the input signal.
The level of the output signal is in-
dependent of the setting of the
Master level control ("Pre Fader").
Illustration 2-2: Balanced XLR male
Illustration 2-3: Balanced XLR female
Application
balanced connection of microphones
2 HOT (+)
2
3 COLD (-)
3
1
1 SHIELD
unbalanced external equipment with XLR-type in/output jacks
balanced external equipment with XLR-type in/output jacks
unbalanced external equipment with phone jack in/output jacks
balanced external equipment with phone jack in/output jacks
D 11A
2, HOT
3, COLD 1, SHIELD
1, SHIELD
3, COLD 2, HOT
7