Step 5 - Using The Digisender® Zx7 - AEI Security & Communications DigiSender ZX7 Mode D'emploi

Step 5 - Using the DigiSender® ZX7
1.
Switch on the source equipment (Satellite,
Freeview, DVD, VCR, etc.).
3.
Select Input 1 by pressing the Power button
again on the Transmitter and Receiver. The
green Input LED will light to indicate which
source is active.
Alternatively press the 'Input 1' but-
ton on the DigiSender® Remote Control.
Please read this instruction manual carefully prior to installation
DG458 - DigiSender® ZX7 - Quad Input 5.8GHz Wireless AV Sender
1 2
T R A N S
2.
POWER
Turn on the Transmitter and Receiver by pushing
the Power button on the front of the units. The
standby LED will change from red to green to indi-
cate the unit is switched on.
POWER
Power button on the DigiSender® Remote Control.
4.
3
On the receiving TV, select the SCART channel
assigned to the SCART socket that you plugged
the Receiver in to. This may be labelled as
SCART, AUX, AV, VIDEO, VCR or
ENGLISH (EN)
Alternatively press the
4
.
Page 09